SRT10 Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Had to confirm if my new-to-me truck had actually been worked on other than the K+N intake, MOPAR headers, high-flow cat pipes and Magnaflow cat back.

463 HP at 5250 RPM
490 TQ at 4250 RPM

I'm most impressed that it made >470 TQ from 3000 RPM to 5250.

Guess I'll post the sheet after a couple more posts. LOL.
 

·
Premium Member
Joined
·
2,600 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #5
 

·
Registered
Joined
·
24 Posts
Discussion Starter #6
Cool. It let me post the graph that time.

Other than determining if the previous owner was a BS artist, (He was), I was also concerned about the AFR. I've seen other vehicles in the past tend to run rather lean if you only swap out breathing accessories. As luck would have it, She runs pretty much right where she should under load so I'm pretty confident I can use the power as intended without too many potential ill effects.

I don't think there has been any tuning done as I don't see any add-on boxes and the ECM appears to be stock.
 

·
Registered
Joined
·
24 Posts
Discussion Starter #8
2evil4u
I'm located in Baton Rouge
Were you one of the SRT-10 RAMs I saw at the Power Tour Finale in Gonzales? I was there in my 502 Chevy powered 37 Ford Coupe.
 

·
Registered
Joined
·
13 Posts
Were you one of the SRT-10 RAMs I saw at the Power Tour Finale in Gonzales? I was there in my 502 Chevy powered 37 Ford Coupe.
No sir. Didn't make it.
I have yellow fever qc. We trying to start a Facebook for Louisiana
Louisiana viper trucks. I live in central actually not far from you.
 
1 - 9 of 9 Posts
Top