SRT10 Forum banner

1 - 20 of 40 Posts

·
Registered
Joined
·
2,911 Posts
Discussion Starter #1
Dave at Roe Racing just called and my Exhaust system is waiting to be installed. I will drop it off Tues and should have it back Wed. They will be Dynoing the truck before and after so I should have some good info to share. I will keep you all posted.
 

·
Registered
Joined
·
17,270 Posts

·
Registered
Joined
·
974 Posts
Marc T said:
Dave at Roe Racing just called and my Exhaust system is waiting to be installed. I will drop it off Tues and should have it back Wed. They will be Dynoing the truck before and after so I should have some good info to share. I will keep you all posted.

The dyno numbers should be very interesting. I am very curious to see how much difference it makes with the vec2 allowing you to retune with the new exhaust system.
 

·
Registered
Joined
·
17,270 Posts

·
Registered
Joined
·
2,911 Posts
Discussion Starter #7
Roktman said:
No Marc I didn`t.Concerened with the emissions check here in the People`s Republic of Ohio. :mad:
Sorry to here that Dave.

I will be removing the cats. The system will be 3 inch from headers back. The B&B system has the high flo cats but we will cut them out and replace them with 3 inch stainless tubing.
 

·
Registered
Joined
·
17,270 Posts

·
Registered
Joined
·
17,270 Posts

·
Registered
Joined
·
2,911 Posts
Discussion Starter #12
Roktman said:
I`m anxious to see what mine will do with the VEC 2 as well.I am doing it late next month.Don`t think I am doing the 4.56 `s right now.Can`t decide if there is enough of a difference to do it.

Just a point to mention!!

Going with the 4:56's will be a little easier on the Clutch.

Just a thought!!
 

·
Registered
Joined
·
17,270 Posts

·
Registered
Joined
·
974 Posts
Whats the word brotha! Don't keep us in suspense :D
 

·
Registered
Joined
·
2,911 Posts
Discussion Starter #16
Help Again

I feel like such an ass. I posted a Dyno PDF file before but I can't remember how to do now?? The file is too big. I need to resize it. Can anyone help. I have all the dyno runs and some photos to boot. HELP!!!!!!
 

·
Registered
Joined
·
2,911 Posts
Discussion Starter #17
Dyno Run with [email protected] and Headers

Well here are the photos, When I can figure out how to resize the PDF file of the dyno I will post it.

The results are pretty interesting. Not as much HP increase as I was hoping but still a significant amount. Then again when is it ever enough??
 

Attachments

·
Registered
Joined
·
17,270 Posts

·
Registered
Joined
·
1,803 Posts
Marc, That is real Sweet, I love seeing those 5 tubes, How does it feel? On a side note, is that a hitch on there? what have you towed? Thanks, Mike
 

·
Registered
Joined
·
2,911 Posts
Discussion Starter #20
Roktman said:
Marc,What were the HP and torque numbers from stock to modded?

Dave,

I can't get the PDF file to load up I Have 3 dynos laid on top of each other, the file is apparently too large and I can't seem to figure out how too resize it!!
 
1 - 20 of 40 Posts
Top