[stinker]

Ok guys now this is a little out there, but I noticed two wholes in the undeside of the front bumper pan. This led me to an idea. I went to lowes and got 2 dryer vents took off the tubes. Then mounted them under there so they would pick up cool air and push it into the engine compartment , also cooler air around the air filter. Now some of you might think up another idea for this(ram air). But for now I just wanted your opinions ,If ya'll think they suck and look stupid , off they come, but if ya'll think something else, if nothing but a cool race car look, then we'll mount permanent or at least a little better. So hey guys give'em here good or bad. Also put a pic of my air filter and the way I put a small scoop in the fender to grab the air to keep it from going on thru the fender.

 

[mauiSRT/10]

Looks kinda cool.....are there gonna be any clearance issues?? In the pic they look low but its hard to tell for sure.... Did you notice any more power after install??

patrick

 

[stinker]

they were still off the ground a good bit, they are only about 3 inches down from bumper if that, and don't know if there will be much performance gain but maybe cooler engine bey temps. Or maybe somebody like 9 seconds that drags alot could make some ram air with some time don't know , its 4 am here in nc usa, just got up an cranked the rig, gotta go back to memphis tn for a load be back in a day or so.