SRT10 Forum banner

Houston area exhaust shop.

2009 Views 4 Replies 2 Participants Last post by  9 seconds
Does anyone know of a quality exhaust shop in the Houston area that is not afraid to fab some pipes for me that don't have cats in them? The local joints here (Brazoria county : also a non-attainment area) are a bit nervous. They don't have to install them on the truck. Just make them. Any tips?

Thanks.
1 - 5 of 5 Posts
9 seconds said:
Does anyone know of a quality exhaust shop in the Houston area that is not afraid to fab some pipes for me that don't have cats in them? The local joints here (Brazoria county : also a non-attainment area) are a bit nervous. They don't have to install them on the truck. Just make them. Any tips?

Thanks.
One of my Dakota RT bros in Houston suggested the following:

"Try MTI (Motorsports Tech Inc), RSi (Racing Solutions Inc), or Conversion Xtras"
Thanks. Already got a "Well, we could" from one of them. Didn't seem interested. I'm check the others.

Steve
2
9 seconds said:
Thanks. Already got a "Well, we could" from one of them. Didn't seem interested. I'm check the others.

Steve
Yeah, everyone has chimed in now that RSi is the place to go. Not sure which one didn't seem interested. Hopefully it wasn't them. ;)

Another guy suggested, "Affordable Muffler (off of Dairy Ashford and Memorial). He's not afraid of doing some custom work."

Apparently RSi is a fairly good place. Photos were offered of the garage:

Attachments

See less See more
RSI is a great place. I've know Jason and Gerald for a few years now. That was their throttle body that I tested and posted results on in the dyno section. They also were the ones who weren't real interested. I understand. Why take a guy off of making $2500+ headers or $30,000 turbo systems to weld up some pipe. I think the muffler shop you mentioned is more what I am looking for. I will be calling them.

Thanks.........again.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top