SRT10 Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
1,494 Posts
Discussion Starter · #4 ·
Initially 150-180. Then 200. I ran that on my Viper when it was stock. I will have to wait until next week for the dyno. Should be able to sneek it in while doing baseline numbers for headers.
 

·
Registered
Joined
·
2,891 Posts
9 seconds said:
Initially 150-180. Then 200. I ran that on my Viper when it was stock. I will have to wait until next week for the dyno. Should be able to sneek it in while doing baseline numbers for headers.
What headers are youo going to run? what primary size?
 

·
Registered
Joined
·
40 Posts
I have a couple of ???>>1.What kind of system did u use?
2. can i use the stock exhaust?
3..where did u bought it?
Thanks in advance.
 

·
Registered
Joined
·
1,494 Posts
Discussion Starter · #11 ·

Attachments

·
Registered
Joined
·
1,675 Posts
yes, if for any reason the engine goes lean (not enough gas) while getting a shot of nos the heat inside the engine will burn up important engine parts, like pistons & valves.
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top