SRT10 Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Please help I need to replace the motor mounts in my truck but I cant find them anywhere, any suggestions would be greatly appreciated.

The truck is an all black Quad cab with no major mods.

I am located in Austin Texas

thanks in advance
 

·
Registered
Joined
·
4 Posts
Please help I need to replace the motor mounts in my truck but I cant find them anywhere, any suggestions would be greatly appreciated.

The truck is an all black Quad cab with no major mods.

I am located in Austin Texas

thanks in advance
 

·
Site SUPER Moderator
Joined
·
6,695 Posts
Actually there are no motor mounts as you know them there are 2 spindles that stick up from the frame and 2 round mounts rings on the engine. The rings simply slide down over the spindles. Weight of engine holds it in place
 

·
Registered
Joined
·
4 Posts
Hmm, I'll have to check under again. Thanks. I'm getting slop when I hit the gas like a motor mount is busted by I've had someone brake it and hit the gas in drive and reverse to seen movement and there is VERY little torquing of the engine occurring. I've had ujoints replaced including center bearing. I replaced rear end oil. Still have this slop when I go from a stop. Any ideas? torque converter? Rear end?
 

·
Registered
Joined
·
105 Posts
Hmm, I'll have to check under again. Thanks. I'm getting slop when I hit the gas like a motor mount is busted by I've had someone brake it and hit the gas in drive and reverse to seen movement and there is VERY little torquing of the engine occurring. I've had ujoints replaced including center bearing. I replaced rear end oil. Still have this slop when I go from a stop. Any ideas? torque converter? Rear end?
There are indeed engine mounts on the Viper Trucks as any vehicle. They are indeed hard to find if not impossible new. We carry many sets of good used ones. Some with great rubber and low miles. Venomous1Racing on FB
 
1 - 7 of 7 Posts
Top