SRT10 Forum banner

Rear brake Kit

2823 Views 4 Replies 4 Participants Last post by  9 seconds
I found this on Summit's site today and thought it mignt be of interest.

all one page | printable page



Should Ship By: Tomorrow

Performance rear-axle drag kits from Wilwood.

Chrysler/Dana: 8 3/4 in./Dana 60 rear axles, green bearing with snap ring, 2.36 in. offset, rear axle drag brake kit

This rear axle drag race kit is designed to reduce ETs by saving up to 35 lbs. of unsprung and rotating weight over stock drum or disc brakes. The kit includes Wilwood's four piston Dynalite II racing calipers with corrosion resistant stainless steel pistons, lightweight steel rotors, and high friction disc brake pads. Brackets, mounting hardware, and detailed instructions complete the kit for an easy bolt-on installation.

Sold as a kit.

Vendor Wilwood
Product Line Wilwood Pro Series Rear Axle Drag Brake Kits

Have any Questions? Give us a call at: 1-800-230-3030 or 1-330-630-3030

Terms and Conditions | Privacy Policy
Copyright © 2004 by AUTOSALES, INC.
dba Summit Racing Equipment | Trademarks
See less See more
1 - 5 of 5 Posts
If this works for you guys it's going to be awsome, finally we'll be able to see some times with traction :cool:

The major problem I see with this set up, is you lose the "emergency" brake. Larry
Mofo said:
The major problem I see with this set up, is you lose the "emergency" brake. Larry
That and they don't fit our trucks. This Dana 60 kit fits axles with 5 bolt axle flanges and ours has 4 bolts. The offset is too short also. My guess is it was meant for older cars w/o the drum E-brake or the Super-60.:(
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.