[Droopy]

This is about my RumbleBee. It's my daily driver. The Bee has a somewhat cheap trim piece on the bottom of the truck full length. On the passenger side is a cutout on the last piece for the exhaust tip to exit. I would like a matching piece on the driver's side so I could have dual exhaust. I've heard of reverse molding as a possible way to get it made. It appears to be a thin fiberglass or something like that. My question is does anyone know of anyone (company/individual) who does this or is talented who can produce this part by any other means? Any help would be appreciated. I go to the rumblebee.org forum and they are GEEKS! No help at all. It's like Forrest Gump. Thanks. Droopy

 

[begood]

couldn't you measure the one on the right, and then notch the one on the left to match?

 

[Marc T]

A good body shop should be able to help you.

 

[Droopy]

The problem is that the exhaust cutout is flaired at the top. If you just cut out the opening it won't have the flair. This is why I wonder about any special method to reproduce the same appearance for the drivers side.