SRT10 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi,

I'm from Austria, Vienna and have imported a RAM SRT-10 Quad cap from US.
I have made a lot of changes to the car (Supercharger, custom made exhaust, brake modifications, uprated automatic transmission,....).
But now I have some troubles with worn parts, on the front axle the upper and lower ball joints and the rear axle bearing.
My question: can I get the ball joints without the control arm or are they only available as one part (complete control arm with ball joints)? Are there reinforced parts on the market?
To the rear bearings, is it hard to get them out of the axle housing (e.g. possible with a sliding hammer?)

I hope you can help me with this and you will excuse my bad english :smile
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top